EEPROM CAS4 - Program Turn Off
Posted: Fri Apr 10, 2020 1:19 pm
I have a problem with the BMW Tool interface with software 1.5.0. When I want to make a key from EEPROM to CAS4 + or CAS4, the program shows you to insert a clean key after pressing the oki for a moment does not respond and then turns off
I read that users' problem has this problem
I have also tried the lower versions of the Bmw Tool and it is the same
Do you have any recommendations on this matter ??
I read that users' problem has this problem
I have also tried the lower versions of the Bmw Tool and it is the same
Do you have any recommendations on this matter ??