Recommend for user with RNS300 RNS310, RNS315, RNS510, RCD300, RCD310, RCD320 , Composit Media STD (5K7035200, MIB2 STD 5C0035680 US , EU, 5L0035680... and all other radio except RCD330 (6RD035187, 6R0035187)
Require SWCM(16) - LowLine , if you have HighLine - need to be recode to LowLine
Find (BLACK) socket which keep connection between PCB and Slip Ring flexi and take it off from PCB

Desolder/remove connector number 4 from PCB

Solder together connectors with pins 1 ,2 ,3

Solder input wires ( RED and Yellow) to next pin’s, make sure wires not touch any move parts inside

Solder main wires to main socket (if you not use MFSW with CCS, ignore WHITE cable)

Change location of 3 wires in Airbag loom (proper location below)

Assembly all and put it back to the car. Install MFSW module with double side tape or Velcro on the steering column

Install proper stalks


THIS IS VERY IMPORTANT , YOU CAN NOT KEEP WIPER STALK with TRIP computer for example or code SWCM to Board computer via Wiper stalk , otherwise instrument cluster might freak out and cannot be operate from MFSW as should be (scroll left / right)
After proper CAN and POWER connection BLUE LED stay ON (go OFF after Ignition OFF)
When you connect MFSW over LIN wire WHITE LED start flashing, when you press CCS button (CCS is ON) , Green LED start illuminate, when module is working RED led illuminate, when module go to “sleep” RED and other led are OFF

Open VCDS and go to 16th controller and code for your car

For those who have external BlueTooth module such as 5P0862335 , 7E0035730 , 7L6035730 , 5N0035730 , 3C8035730 , 1Z0035729 and radio RCD330 (6RD035187, 6R0035187)
Require SWCM(16) - HighLine + Need install MFSW Emulator
Find (BLACK) socket which keep connection between PCB and Slip Ring flexi and take it off from PCB

Remove connector 2,3,4 from PCB, solder PIN 1 with connector for better connection


Mount MFSW Emulator with LIN 2.0 configuration , cut off cables for proper length and solder as picture below (the can not be solder to PIN, that is why we remove connector permanent)


Solder input MFSW Module wires (RED and Yellow) to SlipRing PIN's

Solder main wires to T16 connector socket

Modify back of cover ( cut off piece of plastic which keep WHITE socket (no longer need it)

Check if Airbag loom have proper cables located (if you use genuine MQB Airbag loom , no need to do any changes, just confirm is right)

Install module into the car, Login to module 16 -> coding and code SWCM, code MFSW ONLY

MultiFunction Emulator should be available as subsystem (HORN EMU)

DO NOT CODE Other options such as below:
